ipLDK-100 + VOIBE + выкл/вкл. Опции

[asdal]

Добрый день.
ipLDK-100 (3.0Ah)
VOIBE (B.2Ad)
Не пингуется VOIBE, если выкл/вкл электричество - помогает soft restart, через PGM108.

лог с VOIBE (вкл. станции)

[INIT_SYS] Starting the INIT task...
[INIT_SYS] Auto link setup...
[INIT_SYS] Initializing the ETH device...
[INIT_SYS] ETH driver was not installed!
[VP] xxxx, End of VP init : Complete...
Reset By Watchdog : g_watchdog_disable(0)
[INIT_SYS] Fail, add router!
[INIT_SYS] Initializing the VOIP...
[INIT_SYS] Sending event of COMPLETE...
[INIT_SYS] Ending the INIT task...

===================================================================
ipLDK System, VOIBE Maintenance Utility
Ver. B.2Ad, VOIBE/LDK20(D) 1th
Last updated time & date - 11:14:03, Nov 06 2008
===================================================================

[HTTP] Http server thread started
[HTTP] Http listen socket 1 opened
DIDL_UpdateResourcesLAN -NO RESTART!!
Saved IP: 10.1.2.45
Recvd IP: 10.1.2.45


### [MAC_A]Change of Link Status : UP ###
Start Auto-negotiating... Link re-established! (Auto)100/Full

START H323.
END H323 INITIALIZATION.
START SIP.
END SIP INITIALIZATION.

попытки реанимации

ping 10.1.2.45
Request timed out.
Request timed out.
Request timed out.

maint> link
--- PHY Link Status ---
Link Status : UP
Speed Select : 100Mbps
Duplex Mode : FULL

maint> linkauto
starting the AutoNego...
End of AutoNego
Link Status : UP
Speed Select : 100Mbps
Duplex Mode : FULL

ping 10.1.2.45
Request timed out.
Request timed out.
Request timed out.

лог с VOIBE (soft restart станции)

[INIT_SYS] Starting the INIT task...
[INIT_SYS] Auto link setup...
[INIT_SYS] Initializing the ETH device...
[INIT_SYS] ETH driver was successfully installed!
AutoNego Result : Full-Duplex, 100Mbps, LINK-UP
[INIT_SYS] Initializing the VOIP...
[INIT_SYS] Sending event of COMPLETE...
[INIT_SYS] Ending the INIT task...

===================================================================
ipLDK System, VOIBE Maintenance Utility
Ver. B.2Ad, VOIBE/LDK20(D) 1th
Last updated time & date - 11:14:03, Nov 06 2008
===================================================================

[HTTP] Http server thread started
[HTTP] Http listen socket 1 opened


### [MAC_A]Change of Link Status : UP ###
Start Auto-negotiating... Link re-established! (Auto)100/Full
DIDL_UpdateResourcesLAN -NO RESTART!!
Saved IP: 10.1.2.45
Recvd IP: 10.1.2.45
[VP] xxxx, End of VP init : Complete...

START H323.
END H323 INITIALIZATION.
START SIP.
END SIP INITIALIZATION.

все заработало
Reply from 10.1.2.45: bytes=1 time=1ms TTL=252
Reply from 10.1.2.45: bytes=1 time<1ms TTL=252
Reply from 10.1.2.45: bytes=1 time<1ms TTL=252
Reply from 10.1.2.45: bytes=1 time=1ms TTL=252

[harris]

Что подразумевается под "выкл/вкл электричества"???
Сбой в электропитании станции или же всего офиса, включая ваши сетевые коммутаторы??
ИМХО, это проблема не в станции, а в коммутаторе...

[asdal]

выкл/вкл = вынуть шнур от LDK-100 из розетки 220V и вставить обратно.
еще тесты.
отключил патч-корд от VOIBE (B.2Ad).
делаю выкл/вкл.

maint> link
--- PHY Link Status ---
Link Status : UP
Speed Select : 100Mbps
Duplex Mode : FULL

делаю soft restart

maint> link
--- PHY Link Status ---
Link Status : DOWN
Speed Select : 100Mbps
Duplex Mode : FULL

поменял данную плату на другую VOIBE 2.1Dc
после выкл/вкл (пачт-корд отключен) сразу все ок:

maint> link
--- PHY Link Status ---
Link Status : DOWN
Speed Select : 100Mbps
Duplex Mode : FULL

после выкл/вкл (пачт-корд подключен) сразу все ок:

maint> link
--- PHY Link Status ---
Link Status : UP
Speed Select : 100Mbps
Duplex Mode : FULL

Reply from 10.1.2.45: bytes=1 time=1ms TTL=252
Reply from 10.1.2.45: bytes=1 time<1ms TTL=252
щас буду тестировать проблема в плате или прошивки.

[asdal]

всем спасибо.
проблема в плате VOIBE.